Hustler 6btv antenna manual
Candice Age: 29. Is there any chance that my wife and I can see more pics of you and perhaps communicate with you to become friends?I am Angella
NOTE: The Hustler RMS and RMS resonators are the same. Place the antenna on the bracket assembly and set dimension “A”, using the last clamp.
Description:The tubing extending from the inside of the trap is the length to be adjusted using the chart lengths above! As soon as I started testing the antenna with the MFJ I realised whoever had the Hustler previously either had it raised on a mast or used it as a ground base but with limited radials. The total length from the end of the tubing to the point where it touches the trap housing is the length to be adjusted. Start at the lowest frequency of the SWR curve and record measurements upward at frequencies through the entire SWR curve. Then slide if off of the tubing that leads to the trap to be adjusted. Of course some like myself tend to buy antennas as opposed to experiment with antennas.